IS32FL3265A-ZLA3-TR

Lumissil
870-IS32FL3265AZLA3T
IS32FL3265A-ZLA3-TR

制造商:

说明:
LED照明驱动器IC 18 high voltage(40V) constant current channels, eTSSOP-28 (9.7mm x 6.4mm), T&R

ECAD模型:
下载免费库加载程序,将此文件转换,以供您的ECAD工具使用。了解详情。

库存量: 2,886

库存:
2,886 可立即发货
生产周期:
26 周 大于所示数量的预计工厂生产时间。
最少: 1   倍数: 1
单价:
¥-.--
总价:
¥-.--
预估关税:

定价 (含13% 增值税)

数量 单价
总价
¥21.3457 ¥21.35
¥15.9669 ¥159.67
¥14.5544 ¥363.86
¥13.0741 ¥1,307.41
¥12.4074 ¥3,101.85
¥11.9102 ¥5,955.10
¥11.5825 ¥11,582.50
整卷卷轴(请按2500的倍数订购)
¥11.1644 ¥27,911.00

产品属性 属性值 选择属性
Lumissil
产品种类: LED照明驱动器IC
18 Output
Boost, Buck
60 mA
5.5 V
2.7 V
1 MHz
Adjustable
- 40 C
+ 125 C
Constant Current
Reel
Cut Tape
商标: Lumissil
组装国: Not Available
扩散国家: Not Available
原产国: TW, CN
输入电压: 2.7 V to 5.5 V
湿度敏感性: Yes
安装风格: SMD/SMT
通道数量: 18 Channel
产品类型: LED Lighting Drivers
工厂包装数量: 2500
子类别: Driver ICs
电源电流—最大值: 9 mA
找到的产品:
要显示类似产品,至少选中一个复选框
要显示该类别下的类似产品,请至少选中上方的一个复选框。
已选择的属性: 0

USHTS:
8542390090
TARIC:
8542399000
ECCN:
EAR99

IS32LT3175N/P Single-Channel Linear LED Drivers

ISSI IS32LT3175N/P Single-Channel Linear LED Drivers come with fade in/out and PWM dimming. The regulators serve as a stand-alone LED driver-configurable from 20mA to 150mA with external resistors, no microcontroller is necessary. A logic level “courtesy light” signal from the PWM pin can be interfaced to precisely drive the LED channel. The IS32LT3175P obtains a positive polarity PWM signal. In addition, the IS32LT3175N obtains a negative polarity PWM signal. The regulator integrates a 63-step fade-in and fades out the algorithm (Gamma correction). This causes the output LED current to increasingly rise up to the full source value after the EN pin is pulsed.

IS32FL3265 LED Drivers

Lumissil IS32FL3265 LED Drivers are designed with 18 high voltage (40V) constant current 8-bits Pulse Width Modulated (PWM) channels for smooth LED brightness control. These LED drivers provide an 8-bit output current control register on each channel that allows fine-tuning of the channel current for rich RGB color mixing. The IS32FL3265 LED drivers offer programmable H/L logic, accurate color rendition, clock IO pin for multi-chip synchronization, and thermal roll-off programmable set point. These LED drivers can be configured to a minimum current consumption mode by either pulling the SDB pin low or by using the software shutdown feature.